Studi Eksperimen Uji Kuat Tekan, Geser dan Tarik Lentur Pasangan Batu Merah Lokal Produksi Daerah Blitar

rustam rustam, armin naibaho, Galih Damar Pandulu

Abstract


On a thesis is conducting research and testing a red stone against strong press , slide and pull in a pair of red stone that came from three local namely kecamatan Wates the sample, Sanan kulon sub-district , and the kecamatan Srengat all located in the Blitar district . The purpose of experiments in this research is to observe strong destroyed the couple
local brick with the volume of a mixture of one part portland cement: 3 of the tide of sand, and observing strong lekatan sliding a pair of bricks with a mixture of the volume of mortar that same with strong destroyed namely 1 part portland cement: 3 of the sand on thesis is conducting research and testing a red stone against strong press, slide and pull in a pair of local red stone that came from three regions in the sample is Wates, Sanan kulon subdistrict , and the kecamatan Srengat all located in the Blitar district. The results of testing strong press a pair of red stone of each region production different , the third in production after the test , a red stone from the production of Wates regions have the power to press the average highest namely by fk = 35 , 67 kg per cm2 .The order of strong press next namely those Sanan kulon of fk = 33,52 kg per cm2 Srengat areas later by fk = 32,20 kg per cm2. Sliding strong performance also show different numbers at each region production bricks from other regions Wates = fcs the average 5.44 kg per cm2, Sanan kulon fcs the average = 4,77 kg per cm2 Srengat areas later fcs an average of = 4,06 kg per cm2.
Test shows a strong sliding also different in each region production of bricks from the fcs Wates average = 5.44 kg per cm2 , Sanan kulon fcs average = 4,77 kg per cm2 areas later an average of fcs Srengan = 4,06 kg per cm2 . To vigorous pull pliable also shows as distinct from each origin its production that is, strong pull pliable regions of Wates fcs = 2.17 kg per cm2, strong pull pliable Sanan kulon fcs = 2,08 kg per cm2 , strong pull pliable Srengat regions fcs = 8 kg per cm2

Keywords: Brick, strong press, strong sliding, strong pull pliable, blitar

References


ASTM C 67-03, (2003), Standard Test Methods for Sampling and Testing Brick and Structural Clay Tile, USA.

ASTM E 518-03, (2003), Standard Test Methods for Flexural Bond Strength of Mansonry, USA.

Jurnal Rekayasa Sipil, Edisi Volume 4, No. 2, Oktober 2008

SNI 03-4164-1996 (2002), Metoda Pengujian Kuat Tekan Dinding Pasangan Bata Merah

Laboratorium, Balitbang Kimpraswil, Bandung. SNI 03-4165-1996, (2002), Metoda Pengujian Kuat Lentur Dinding Pasangan Bata Merah di Laboratorium, Balitbang Kimpraswil, Bandung.

SNI 03-4166-1996, (2002), Metoda Pengujian Kuat Geser Dinding Pasangan Bata Merah di Laboratorium, Balitbang Kimpraswil, Bandung.

Somayaji, Shan, (2001), Civil Enggineering Materials, 2nd ed., California

Polytechnic State University, San Luis Obisco.

Yunaefi, Ir. MT., Petunjuk Praktikum Bahan Bangunan I, PEDC, Dirjen Dikti, Departemen Pendidikan dan Kebudayaan, 1996.


Refbacks

  • There are currently no refbacks.


Copyright (c) 2018 eUREKA



eUREKA : Jurnal Penelitian Teknik Sipil dan Teknik Kimia

ISSN 2548-771X (online)

Email : [email protected]

 

Editorial Office :
Fakultas Teknik, Universitas Tribhuwana Tunggadewi Malang

Jl. Telaga Warna Blok C, Tlogomas, MALANG 65144, Jawa Timur
Tel / fax : (0341) 565 500 / (0341) 565 522

 

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License

 

View My Stats